telefon-logo
kontakt-logo

BF customized borehole

Bremsfangvorrichtung / Baureihe BF / EN81-20 / Sautter Lift Components GmbH / SLC
Homepage » Safety Gears » Bf series » BF customized borehole

Adaptation to existing car by customized boreholes

Our strength is the adaptation of our safety gears to your individual modernization task. Borehole modifications to our outer housings optimize the interface with your existing interception frame. The assembly effort on site is reduced and makes you significantly faster.

For flexible adaptation of the hole patterns for attaching the safety gear to the car, our reinforced outer housing (SLC part number 50.100.225) for the one-piece BF safety gear and the outer housing for the tandem safety gear (SLC part number 107.060.131) are suitable. Please refer to the following sketch for the dimensions of these two housings:

When the safety gear is attached to the lower crossbar of the safety gear frame, the housing is attached to the frame with side A, and the guide shoes are attached to side B. We can adjust both plates according to your requirements.

Adjustment of the head plate “A”

The following sketch shows the possibilities for mounting on the car frame:

 

You should consider the following points when determining the mounting holes:

      • The holes must of course be inside the plate (420 x 160mm), with sufficient distance to the plate edge
      • The fastening must be made with at least 4 M12 screws of strength class 12.9 or a comparable or higher-quality fastening.
      • When determining the holes, you must take into account the position of the side parts (see sketch of the outer casing)
      • The edge of the plate is located at a distance of 10mm from the rail head
      • You can choose round holes or oblong holes. Please make a selection for hole line 1 and hole line 2 respectively

Adjustment of the bottom plate “B”

The following sketch shows the possibilities for mounting the guide shoes:

 

You should consider the following points when determining the mounting holes:

      • The holes must be inside the plate (420 x 160mm), with sufficient distance to the plate edge
      • Mounting can be done with 2 or 4 screws / bolts
      • When determining the holes, you must take into account the position of the side parts (see sketch of the outer casing)
      • The edge of the plate is located at a distance of 10mm from the rail head
      • You can choose round holes or oblong holes. Please make a selection for hole line 1 and hole line 2 respectively
      • Please decide whether the standard hole pattern for the guide shoes option “3” should be omitted (there are also customer applications with 6 or 8 holes).

Here you will find the inquiry/order sheet for the specification of the hole pattern changes on the standard housing:

 

If you cannot realize the attachment of our safety gear with a hole pattern change, an additional adapter plate may be the solution to your problem.

Here we show you the attachment with the help of additional adapter plates